LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2020 >> Corolla L >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 25 (Emission Control System (M20A-FKS) - Service Information) >> EGR Valve >> Removal [06/2018 - 09/2019] >> Procedure

Removal [06/2018 - 09/2019]: Procedure

WARNING: This page is about a different variant/trim than selected.
  1. DRAIN ENGINE COOLANT 

    Refer to PROCEDURE - Step 1

  2. REMOVE EGR COOLER ASSEMBLY 

    See step  5 [06/2018 - 01/2019], or see step  5 [01/2019 - 03/2019], or see step  5 [03/2019 - 09/2019]

  3. REMOVE NO. 1 EGR PIPE SUB-ASSEMBLY 
    1. Disconnect the EGR valve assembly connector.
      GTY837237Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Using an 8 mm socket wrench, remove the 4 bolts and No. 1 EGR pipe sub-assembly from the intake manifold and EGR valve assembly.
      GTY837911Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    3. Remove the EGR valve adapter gasket from the No. 1 EGR pipe sub-assembly.
      GTY823565Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    4. Remove the EGR inlet gasket from the intake manifold.
      GTY823574Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  4. REMOVE EGR VALVE ASSEMBLY 
    1. Slide the clip and remove the No. 4 water by-pass hose from the EGR valve assembly.
      GTY788434Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *1 No. 4 Water By-pass Hose
      *2 No. 8 Water By-pass Hose
    2. Slide the clip and disconnect the No. 8 water by-pass hose from the EGR valve assembly.
    3. Using the 8 mm socket wrench, remove the 2 bolts and EGR valve assembly.
      GTY823573Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals