Components [03/2019 - 11/2022]
WARNING: This page is about a different variant/trim than selected.
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
| Callout |
Description |
Callout |
Description |
| *A |
w/o Neutral Position Switch |
*B |
w/ Neutral Position Switch |
| *1 |
MANUAL TRANSMISSION FILLER PLUG |
*2 |
MANUAL TRANSMISSION DRAIN PLUG |
| *3 |
BACK-UP LIGHT SWITCH ASSEMBLY |
*4 |
NEUTRAL POSITION SWITCH |
| *5 |
TRANSMISSION REVOLUTION SENSOR |
*6 |
GASKET |
| *7 |
O-RING |
*8 |
MANUAL TRANSMISSION CASE PLUG |
|
N.m (kgf/cm, ft.lbf): Specified torque |
• |
Non-reusable part |
|
Toyota Genuine Adhesive 1324, Three Bond 1324 or equivalent |
* |
Precoated part |
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
| Callout |
Description |
Callout |
Description |
| *1 |
RELEASE CYLINDER BLEEDER PLUG CAP |
*2 |
RELEASE CYLINDER BLEEDER PLUG |
| *3 |
CLUTCH RELEASE BLEEDER SUB-ASSEMBLY |
*4 |
CLUTCH RELEASE CYLINDER WITH BEARING ASSEMBLY |
| *5 |
CLUTCH RELEASE CYLINDER WITH BEARING ASSEMBLY TO BLEEDER TUBE |
*6 |
CLAMP |
|
Tightening torque for "Major areas involving basic vehicle performance such as moving/turning/stopping": N.m (kgf/cm, ft.lbf) |
|
N.m (kgf/cm, ft.lbf): Specified torque |
| * |
For use with union nut wrench |
• |
Non-reusable part |
|
Clutch spline grease |
* |
Precoated part |
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
| Callout |
Description |
Callout |
Description |
| *1 |
SHIFT AND SELECT LEVER SHAFT STRAIGHT SCREW WITH HEAD PLUG |
*2 |
NO. 2 LOCK BALL PIN RETURN SPRING |
| *3 |
LOCK BALL PIN |
*4 |
NO. 1 LOCK BALL PIN RETURN SPRING |
| *5 |
NO. 2 LOCK BALL PIN |
*6 |
SHIFT DETENT BALL PLUG |
| *7 |
NO. 2 SHIFT DETENT BALL COMPRESSION SPRING |
*8 |
SHIFT DETENT BALL |
| *9 |
SHIFT DETENT BALL COMPRESSION SPRING |
*10 |
MANUAL TRANSMISSION CASE |
| *11 |
INNER SELECT LEVER SET BOLT |
*12 |
OUTER SELECT LEVER |
| *13 |
SHIFT AND SELECT LEVER SHAFT ASSEMBLY |
*14 |
INNER SELECT LEVER |
| *15 |
OUTER SELECT LEVER OIL SEAL |
- |
- |
|
N.m (kgf/cm, ft.lbf): Specified torque |
• |
Non-reusable part |
|
Toyota Genuine Adhesive 1324, Three Bond 1324 or equivalent |
|
MP grease |
| * |
Precoated part |
- |
- |
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
| Callout |
Description |
Callout |
Description |
| *1 |
INPUT SHAFT ASSEMBLY |
*2 |
OUTPUT SHAFT ASSEMBLY |
| *3 |
NO. 2 OUTPUT SHAFT ASSEMBLY |
*4 |
DIFFERENTIAL CASE ASSEMBLY |
| *5 |
NO. 1 GEAR SHIFT HEAD |
*6 |
NO. 1 GEAR SHIFT FORK ASSEMBLY |
| *7 |
NO. 1 GEAR SHIFT FORK SHAFT |
*8 |
SHIFT HEAD SET SLOTTED SPRING PIN |
| *9 |
SHIFT FORK SLOTTED PIN |
*10 |
NO. 2 GEAR SHIFT FORK ASSEMBLY |
| *11 |
NO. 3 GEAR SHIFT FORK ASSEMBLY |
*12 |
NO. 4 GEAR SHIFT FORK |
| *13 |
NO. 4 GEAR SHIFT FORK SHAFT |
*14 |
FRONT DIFFERENTIAL CASE FRONT TAPERED ROLLER BEARING (INNER RACE) |
| *15 |
FRONT DIFFERENTIAL CASE REAR TAPERED ROLLER BEARING (INNER RACE) |
- |
- |
|
N.m (kgf/cm, ft.lbf): Specified torque |
• |
Non-reusable part |
|
Toyota Genuine Adhesive 1324, Three Bond 1324 or equivalent |
* |
Precoated part |
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
| Callout |
Description |
Callout |
Description |
| *1 |
FRONT DIFFERENTIAL CASE FRONT TAPERED ROLLER BEARING (OUTER RACE) |
*2 |
TRANSMISSION MAGNET |
| *3 |
BREATHER PLUG |
*4 |
FRONT OUTPUT SHAFT BEARING (OUTER RACE) |
| *5 |
OUTPUT SHAFT (MTM) COVER |
*6 |
REVERSE GEAR SHAFT COVER |
| *7 |
FRONT DIFFERENTIAL OIL BAFFLE |
*8 |
FRONT TRANSAXLE CASE OIL SEAL |
| *9 |
FRONT DRIVE SHAFT OIL SEAL RH |
*10 |
TRANSAXLE CASE STRAIGHT PIN |
| • |
Non-reusable part |
|
MP grease |
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
| Callout |
Description |
Callout |
Description |
| *1 |
REAR REVERSE GEAR SHAFT BEARING SHIM |
*2 |
REAR INPUT SHAFT BEARING SHIM |
| *3 |
INPUT SHAFT (MTM) COVER |
*4 |
NO. 1 OIL RECEIVER PIPE (MTM) |
| *5 |
INNER SHIFT LEVER SLOTTED SPRING PIN |
*6 |
INNER NO. 1 SHIFT LEVER |
| *7 |
OUTER NO. 1 SHIFT LEVER |
*8 |
OUTER SHIFT LEVER OIL SEAL |
| *9 |
REAR OUTPUT SHAFT BEARING (OUTER RACE) |
*10 |
FRONT DRIVE SHAFT OIL SEAL LH |
| *11 |
FRONT DIFFERENTIAL CASE REAR TAPERED ROLLER BEARING (OUTER RACE) |
*12 |
REAR OUTPUT SHAFT BEARING SHIM |
| *13 |
FRONT DIFFERENTIAL CASE REAR SHIM |
- |
- |
| • |
Non-reusable part |
|
MP grease |