DTC P0914-12: Gear Shift Position Circuit Short to Battery [06/2018 - 09/2022]: Description
WARNING: This page is about a different variant/trim than selected.
A magnet is installed to the shift fork. When the TCM commands the S1 synchronizer to move, the shift fork moves the S1 synchronizer together and the magnet.
The Hall IC built into the shift stroke sensor converts the magnet position into a voltage signal and sends it to the TCM. The TCM judges the S1 synchronizer operating condition (whether the S1 synchronizer is engaged or released) based on this signal.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | MIL | Memory | Note |
|---|---|---|---|---|---|---|
| P0914-12 | Gear Shift Position Circuit Short to Battery | A short to +B is detected in the shift stroke sensor circuit for 5 seconds or more (1-trip detection logic). |
|
Comes on | DTC stored | SAE Code: P0917 |