LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2020 >> Corolla L >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 215 (Engine Mechanical System (M20A-FKS) - Service Information (2 Of 6)) >> Front Crankshaft Oil Seal >> Removal [06/2018 - 03/2019] >> Procedure

Removal [06/2018 - 03/2019]: Procedure

WARNING: This page is about a different variant/trim than selected.
  1. REMOVE FRONT WHEEL RH 

    Refer to REMOVAL [06/2018 - 01/2019] , or refer to REMOVAL [01/2019 - 03/2019]

  2. REMOVE NO. 1 ENGINE UNDER COVER ASSEMBLY 

    Refer to PROCEDURE - Step 9 [06/2018 - 01/2019] , or refer to PROCEDURE - Step 9 [01/2019 - 03/2019]

  3. REMOVE REAR ENGINE UNDER COVER RH 

    Refer to PROCEDURE - Step 11 [06/2018 - 01/2019] , or refer to PROCEDURE - Step 11 [01/2019 - 03/2019]

  4. REMOVE REAR SIDE RAIL REINFORCEMENT SUB-ASSEMBLY RH 

    Refer to PROCEDURE - Step 11 [06/2018 - 01/2019] , or refer to PROCEDURE - Step 11 [01/2019 - 09/2022]

  5. REMOVE V-RIBBED BELT 

    Refer to PROCEDURE - Step 2 [06/2018 - 01/2019] , or refer to PROCEDURE - Step 2 [01/2019 - ]

  6. REMOVE CRANKSHAFT PULLEY ASSEMBLY 

    Refer to PROCEDURE - Step 15

  7. REMOVE TIMING CHAIN COVER OIL SEAL 
    1. Using a screwdriver, pry out the timing chain cover oil seal.
      GTY787093Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *a Protective Tape
      NOTE:

      Do not damage the surface of the timing chain cover oil seal press fit hole or the crankshaft.

      HINT: 

      Tape the screwdriver tip before use.

scientia non olet · About LEMON Manuals