Adjustment [06/2018 - 09/2024]: Procedure

1. Fully apply the parking brake and chock a wheel.
   WARNING:

   • Make sure to apply the parking brake and chock a wheel before performing this procedure.
   • If the vehicle is not secure and the shift lever is moved to N, the vehicle may suddenly move, possibly resulting in an accident or serious injury.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Refer to REMOVAL [06/2018 - 01/2019] , or refer to REMOVAL [01/2019 - 03/2019] , or refer to REMOVAL [03/2019 - 09/2022] , or refer to REMOVAL [09/2022 - 11/2022] , or refer to REMOVAL [11/2022 - 09/2024] 

1. Disconnect the park/neutral position switch assembly connector.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

2. Using a piece of wood or equivalent to secure the transmission control shaft lever to prevent it from rotating, remove the nut, washer and transmission control shaft lever from the manual valve lever shaft.
   NOTE:

   If the transmission control shaft lever is not secured when loosening the nut, the manual valve link lever sub-assembly may separate from the manual valve.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   *1	Transmission Control Shaft Lever
   *a	Manual Valve Link Lever Sub-assembly
   *b	Manual Valve

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   *a	Piece of Wood or Equivalent

3. Loosen the 2 bolts of the park/neutral position switch assembly.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

4. Align the protrusions of the park/neutral position switch assembly as shown in the illustration.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   *a	Protrusion

5. Hold the park/neutral position switch assembly in that position and tighten the 2 bolts.

   Torque: 5.4 N.m (55 kgf/cm, 48 in.lbf) 

6. Install the transmission control shaft lever to the manual valve lever shaft with the washer and nut.

   Torque: 12.7 N.m (130 kgf/cm, 9 ft.lbf) 

7. Connect the park/neutral position switch assembly connector.

Refer to INSTALLATION [06/2018 - 03/2019] , or refer to INSTALLATION [03/2019 - 09/2024] 

See step  2