LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2020 >> Corolla L >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 17 (Automatic Transaxle System (K120 / K121) - Service Information (3 Of 5)) >> Oil Cooler >> Removal [06/2018 - 09/2019] >> Procedure

Removal [06/2018 - 09/2019]: Procedure

WARNING: This page is about a different variant/trim than selected.
  1. REMOVE NO. 1 ENGINE UNDER COVER ASSEMBLY 

    Refer to PROCEDURE - Step 9 [06/2018 - 01/2019] , or refer to PROCEDURE - Step 9 [01/2019 - 03/2019] , or refer to PROCEDURE - Step 9 [03/2019 - 09/2019]

  2. REMOVE REAR ENGINE UNDER COVER LH 

    Refer to PROCEDURE - Step 10 [06/2018 - 01/2019] , or refer to PROCEDURE - Step 10 [01/2019 - 03/2019] , or refer to PROCEDURE - Step 10 [03/2019 - 09/2019]

  3. DRAIN ENGINE COOLANT 

    Refer to PROCEDURE - Step 1

  4. DRAIN CONTINUOUSLY VARIABLE TRANSAXLE FLUID 

    See step  3 [06/2018 - 01/2019], or see step 3 [01/2019 - 09/2022]

  5. DISCONNECT NO. 4 WATER BY-PASS HOSE 
    1. Disengage the hose clamp to disconnect the No. 4 water by-pass hose from the No. 1 water hose clamp bracket.
      GTY845498Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Slide the clip and disconnect the No. 4 water by-pass hose from the transmission oil cooler.
  6. DISCONNECT INLET WATER HOSE 
    1. Slide the clip and disconnect the inlet water hose from the transmission oil cooler.
      GTY845499Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  7. REMOVE TRANSMISSION OIL COOLER 
    1. Remove the 3 bolts and transmission oil cooler from the transaxle housing.
      GTY845802Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Remove the 2 O-rings from the transaxle housing.
      GTY787392Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals