LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2020 >> Corolla L >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 17 (Automatic Transaxle System (K120 / K121) - Service Information (3 Of 5)) >> Front Differential Oil Seal >> Replacement [09/2022 - 11/2022] >> Procedure

Replacement [09/2022 - 11/2022]: Procedure

WARNING: This page is about a different variant/trim than selected.
  1. REMOVE FRONT DRIVE SHAFT ASSEMBLY 

    Refer to REMOVAL [09/2022 - 11/2022]

  2. REMOVE FRONT DRIVE SHAFT OIL SEAL LH 
    1. Using SST, remove the front drive shaft oil seal LH from the continuously variable transaxle assembly.
      GTY910349Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      • SST: 09308-00010 
      NOTE:

      Do not damage the continuously variable transaxle assembly.

  3. REMOVE FRONT DRIVE SHAFT OIL SEAL RH 
    1. Using SST, remove the front drive shaft oil seal RH from the continuously variable transaxle assembly.
      GTY841906Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      • SST: 09308-00010 
      NOTE:

      Do not damage the continuously variable transaxle assembly.

  4. INSTALL FRONT DRIVE SHAFT OIL SEAL LH 
    1. Using SST and a hammer, install a new front drive shaft oil seal LH to the continuously variable transaxle assembly.
      GTY913550Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      • SST: 09950-70010 
        1. 09951-07150
      • SST: 09649-17010 

      Standard Depth

      -0.5 to 0.5 mm (-0.0197 to 0.0197 in.)

      NOTE:
      • Be sure to install the front drive shaft oil seal LH in the correct direction.
      • Make sure to install the front drive shaft oil seal LH as specified, otherwise malfunctions such as a fluid leak will occur.
      • Do not damage the lip of the front drive shaft oil seal LH.
  5. INSTALL FRONT DRIVE SHAFT OIL SEAL RH 
    1. Using SST and a hammer, install a new front drive shaft oil seal RH to the continuously variable transaxle assembly.
      GTY904701Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      • SST: 09950-70010 
        1. 09951-07150
      • SST: 09316-10010 

      Standard Depth

      -0.5 to 0.5 mm (-0.0197 to 0.0197 in.)

      NOTE:
      • Be sure to install the front drive shaft oil seal RH in the correct direction.
      • Make sure to install the front drive shaft oil seal RH as specified, otherwise malfunctions such as a fluid leak will occur.
      • Do not damage the lip of the front drive shaft oil seal RH.
  6. INSTALL FRONT DRIVE SHAFT ASSEMBLY 

    Refer to INSTALLATION [09/2022 - 11/2022]

scientia non olet · About LEMON Manuals