DTC P1610-09: Control Module Processor (Brake Override System Input Signal) Component Failure [09/2022 - 11/2022]: Procedure

1. Clear the DTCs.

   Powertrain > Engine > Clear DTCs 

2. Turn the ignition switch off and wait for at least 30 seconds.

   Result

   Proceed to
   NEXT

Result: 

NEXT 

See step  2

1. Drive the vehicle in accordance with the driving pattern described in Confirmation Driving Pattern.
2. Read the DTCs.

   Powertrain > Engine > Trouble Codes 

   Result

   Result	Proceed to
   DTCs are not output	A
   DTC P1610-09 is output	B

Result: 

A 

CHECK FOR INTERMITTENT PROBLEMS 

Refer to CHECK FOR INTERMITTENT PROBLEMS [06/2018 - ]

Result: 

B 

REPLACE ECM 

Refer to REMOVAL [09/2022 - 11/2022]