LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2020 >> Corolla L >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 16 (Automatic Transaxle System (K120) - Diagnostics - Introduction (1 Of 2)) >> K120 Continuously Variable Transaxle System >> Registration [06/2018 - 09/2024] >> Caution / Notice / Hint

Caution / Notice / Hint

WARNING: This page is about a different variant/trim than selected.
NOTE:
  • When the continuously variable transaxle assembly is replaced, the transaxle compensation code must be registered to the TCM (Procedure 1).

    After the continuously variable transaxle assembly is installed, the Quick Response (QR) code label will be positioned where the code cannot be read. Therefore, before installing the continuously variable transaxle assembly, record the transaxle compensation code or register it using the Techstream.

  • When the TCM is replaced, the existing transaxle compensation code must be registered to the new TCM (Procedure 2).
  • Perform Reset Memory after replacing the continuously variable transaxle parts.

    Refer to INITIALIZATION [06/2018 - 09/2022] , or refer to INITIALIZATION [09/2022 - 11/2022] , or refer to INITIALIZATION [11/2022 - 09/2024] 

scientia non olet · About LEMON Manuals