DTC P0335-2A: Crankshaft Position Sensor "A" Signal Stuck in Range [03/2019 - 09/2019]: Description

WARNING: This page is about a different variant/trim than selected.

Refer to DTC P0335-11.

DTC No.	Detection Item	DTC Detection Condition	Trouble Area	MIL	Memory	Note
P0335-2A	Crankshaft Position Sensor "A" Signal Stuck in Range	Diagnosis condition: Engine cranking Abnormal condition: No crankshaft position sensor signal. Malfunction time: 4.7 seconds or more Trip logic: 1 trip detection logic Detection conditions: Continuous Sensors/components used for detection (Main): Crankshaft position sensor Sensors/components used for detection (Related): Camshaft position sensor	Open or short in crankshaft position sensor circuit Crankshaft position sensor ECM	Comes on	DTC stored	SAE Code: P0335 DTC for Mexico Models: Applies

DTC No.

Detection Item

DTC Detection Condition

Trouble Area

MIL

Memory

Note

P0335-2A

Crankshaft Position Sensor "A" Signal Stuck in Range

Diagnosis condition:

Abnormal condition:

Malfunction time:

Trip logic:

Detection conditions:

Sensors/components used for detection (Main):

Sensors/components used for detection (Related):

Comes on

DTC stored