DTC P0010-01: Camshaft Position "A" Actuator Bank 1 General Electrical Failure [06/2018 - 03/2019]: Procedure
WARNING: This page is about a different variant/trim than selected.
- INSPECT CAMSHAFT TIMING GEAR ASSEMBLY
*1 Camshaft Timing Gear Assembly *2 Eccentric Shaft *a Spline - Remove the cam timing control motor with EDU assembly.
Refer to REMOVAL [06/2018 - 01/2019] , or refer to REMOVAL [01/2019 - 03/2019]
- Check if the eccentric shaft of the camshaft timing gear assembly rotates smoothly.NOTE:
If the camshaft is at a position where a valve is about to open, the eccentric shaft may become difficult to rotate.
OK
Rotates smoothly.
HINT:
Perform "Inspection After Repair" after replacing the camshaft timing gear assembly, or removing or replacing the cam timing control motor with EDU assembly.
Refer to INITIALIZATION [06/2018 - 09/2019]
Result
Proceed to OK NG
Result:
OK
REPLACE CAM TIMING CONTROL MOTOR WITH EDU ASSEMBLY
Refer to REMOVAL [06/2018 - 01/2019] , or refer to REMOVAL [01/2019 - 03/2019]
Result:
NG
REPLACE CAMSHAFT TIMING GEAR ASSEMBLY
Refer to REMOVAL [06/2018 - 01/2019] , or refer to REMOVAL [01/2019 - 03/2019]
- Remove the cam timing control motor with EDU assembly.