DTC P0010-01: Camshaft Position "A" Actuator Bank 1 General Electrical Failure [03/2019 - ]: Procedure

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

1. Remove the cam timing control motor with EDU assembly.

   Refer to REMOVAL [03/2019 - 09/2019] , or refer to REMOVAL [09/2019 - 06/2021] , or refer to REMOVAL [06/2021 - 09/2022] , or refer to REMOVAL [09/2022 - 11/2022] , or refer to REMOVAL [11/2022 - 03/2023] , or refer to REMOVAL [03/2023 - 09/2024] , or refer to REMOVAL [09/2024 - ]

2. Check if the eccentric shaft of the camshaft timing gear assembly rotates smoothly.
   NOTE:

   If the camshaft is at a position where a valve is about to open, the eccentric shaft may become difficult to rotate.

   OK

   Rotates smoothly.

   HINT: 

   Perform "Inspection After Repair" after replacing the camshaft timing gear assembly, or removing or replacing the cam timing control motor with EDU assembly.

   Refer to INITIALIZATION [06/2018 - 09/2019] , or refer to INITIALIZATION [09/2019 - 04/2020] , or refer to INITIALIZATION [04/2020 - 11/2022] , or refer to INITIALIZATION [11/2022 - ]

   Result

   Proceed to
   OK
   NG

Result: 

OK 

REPLACE CAM TIMING CONTROL MOTOR WITH EDU ASSEMBLY 

Refer to REMOVAL [03/2019 - 09/2019] , or refer to REMOVAL [09/2019 - 06/2021] , or refer to REMOVAL [06/2021 - 09/2022] , or refer to REMOVAL [09/2022 - 11/2022] , or refer to REMOVAL [11/2022 - 03/2023] , or refer to REMOVAL [03/2023 - 09/2024] , or refer to REMOVAL [09/2024 - ]

Result: 

NG 

REPLACE CAMSHAFT TIMING GEAR ASSEMBLY 

Refer to REMOVAL [03/2019 - 09/2022] , or refer to REMOVAL [09/2022 - 11/2022] , or refer to REMOVAL [11/2022 - 03/2023] , or refer to REMOVAL [03/2023 - 09/2024] , or refer to REMOVAL [09/2024 - ]