Disassembly [06/2018 - ]: Procedure

WARNING: This page is about a different variant/trim than selected.

REMOVE MAGNET STARTER SWITCH ASSEMBLY

Remove the 2 bolts.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

While lifting the rear of the magnet starter switch assembly disconnect it from terminal C.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

*a	Terminal C

While lifting the rear of the magnet starter switch assembly, remove the hook from the pinion drive lever, then remove the magnet starter switch assembly.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

*a	Pinion Drive Lever
*b	Hook

REMOVE STARTER YOKE ASSEMBLY

Remove the 3 through bolts and pull out the starter yoke assembly together with the starter commutator end frame assembly.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

REMOVE STARTER COMMUTATOR END FRAME ASSEMBLY

Remove the starter commutator end frame assembly from the starter yoke assembly.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

*1	Starter Yoke Assembly
*2	Starter Commutator End Frame Assembly

REMOVE STARTER BRUSH HOLDER ASSEMBLY

Remove the starter yoke assembly while holding down the starter armature assembly and starter brush holder assembly with the handle of a hammer.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

*1	Starter Yoke Assembly
*2	Starter Brush Holder Assembly
*3	Starter Armature Assembly
*a	Hammer

HINT:

The starter armature assembly will be attracted by the magnetic field of the starter yoke assembly. Hold the starter armature assembly with the handle of the hammer.

REMOVE STARTER ARMATURE ASSEMBLY

Remove the starter armature assembly from the starter brush holder assembly.

*1	Starter Armature Assembly
*2	Starter Brush Holder Assembly

REMOVE STARTER CENTER BEARING CLUTCH SUB-ASSEMBLY

Remove the rubber seal from the starter drive housing assembly.

Remove the starter center bearing clutch sub-assembly from the starter drive housing assembly.