LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2020 >> Corolla L >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 142 (Engine Starting System (M20A-FKS) - Service Information) >> Relay >> Inspection [03/2023 - ] >> Procedure

Inspection [03/2023 - ]: Procedure

WARNING: This page is about a different variant/trim than selected.
  1. INSPECT STARTER RELAY ASSEMBLY (ST) 
    1. Check the resistance.
      GTY773965Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      1. Measure the resistance according to the value(s) in the table below.

        Standard Resistance

        Tester Connection Condition Specified Condition
        3 - 5 Battery voltage not applied to terminals 1 and 2 10 kΩ or higher
        Battery voltage applied to terminals 1 and 2 Below 1 Ω

        If the result is not as specified, replace the starter relay assembly (ST).

  2. INSPECT NO. 2 STARTER RELAY ASSEMBLY (N/ST) 
    1. Check the resistance.
      GTY773965Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      1. Measure the resistance according to the value(s) in the table below.

        Standard Resistance

        Tester Connection Condition Specified Condition
        3 - 5 Battery voltage not applied to terminals 1 and 2 10 kΩ or higher
        Battery voltage applied to terminals 1 and 2 Below 1 Ω

        If the result is not as specified, replace the No. 2 starter relay assembly (N/ST).

scientia non olet · About LEMON Manuals