DTC P0627-12: Fuel Pump "A" Control Circuit Short to Battery [09/2024 - ]: Procedure
WARNING: This page is about a different variant/trim than selected.
- INSPECT ECM (CHECK FOR SHORT)
*a Front view of wire harness connector
(to Fuel Pump Control ECU)- Disconnect the fuel pump control ECU connector.
- Turn the ignition switch to ON.
- Measure the voltage according to the value(s) in the table below.
Standard Voltage
Tester Connection Condition Specified Condition O172-2 (FPC) - Body ground Ignition switch ON Below 1 V Result
Proceed to OK NG
Result:
OK
REPLACE FUEL PUMP CONTROL ECU
- for Hatchback: Refer to REMOVAL [09/2022 - ]
- for Sedan: Refer to REMOVAL [04/2020 - ]
Result:
NG
See step 2
- CHECK HARNESS AND CONNECTOR (FUEL PUMP CONTROL ECU - ECM)
- Disconnect the fuel pump control ECU connector.
- Disconnect the ECM connector.
- Measure the resistance according to the value(s) in the table below.
Standard Resistance
Tester Connection Condition Specified Condition O172-2 (FPC) or A178-61 (FPC) - Other terminals Always 10 kΩ or higher Result
Proceed to OK NG
Result:
OK
REPLACE ECM
Refer to REMOVAL [09/2024 - ]
Result:
NG
REPAIR OR REPLACE HARNESS OR CONNECTOR