Caution / Notice / Hint
WARNING: This page is about a different variant/trim than selected.
The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during engine assembly removal/installation are shown below.
NECESSARY PROCEDURES AFTER PARTS REMOVED/INSTALLED/REPLACED
| Replaced Part or Performed Procedure | Necessary Procedure | Effect/Inoperative Function when Necessary Procedure not Performed | Link |
|---|---|---|---|
| Replacement of ECM | Vehicle Identification Number (VIN) registration | MIL comes on | Refer to REGISTRATION [06/2018 - ] |
| ECU configuration | - | Refer to ECU CONFIGURATION [09/2022 - ] | |
| Update ECU security key | Vehicle Control History (RoB) are stored | Refer to UPDATE ECU SECURITY KEY [09/2022 - ] | |
| ECU communication ID registration (Immobiliser system) | Engine start function | Refer to REGISTRATION [11/2022 - ] | |
| Replacement of ECM*3 | Code registration (Smart Key System (for Gasoline Model, Start Function)) |
|
Refer to REGISTRATION [11/2022 - ] |
| Replacement of ECM*2 | Code registration (Immobiliser system) |
|
Refer to REGISTRATION [11/2022 - ] |
|
Inspection After Repair |
|
Refer to INITIALIZATION [11/2022 - ] |
| Replacement of continuously variable transaxle assembly |
|
|
Initialization: Refer to INITIALIZATION [03/2023 - ] Registration: Refer to REGISTRATION [03/2023 - ] |
| Replacement of ECM |
|
|
Initialization: Refer to INITIALIZATION [03/2023 - ] Registration: Refer to REGISTRATION [03/2023 - ] |
| Front wheel alignment adjustment |
|
|
w/ Electric Parking Brake System: Refer to UTILITY [11/2022 - ] w/o Electric Parking Brake System: Refer to UTILITY [09/2024 - ] |
| CVT fluid | ATF thermal degradation estimate reset | The value of the Data List item "ATF Thermal Degradation Estimate" is not estimated correctly | Refer to INITIALIZATION [03/2023 - ] |
|
for TMC Made
|
- | Refer to CALIBRATION [09/2022 - ] |
*1: w/ Steering Lock Function
*2: w/o Smart Key System
*3: w/ Smart Key System
*4: If matchmarks were not placed when removing parts related to steering operation, perform end position initial setting.
*5: If transaxle compensation code read from ECM
*6: If transaxle compensation code not read from ECM
WARNING:
- The engine assembly with transaxle is very heavy. Be sure to follow the procedure described in the repair information, or the engine lifter may suddenly drop or the engine assembly with transaxle may fall off the engine lifter.
*a An Object Exceeding Weight Limit of Engine Lifter - To prevent burns, do not touch the engine, exhaust manifold or other high temperature components while the engine is hot.
HINT:
When the cable is disconnected / reconnected to the battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.
LEARNING COMPLETES WHEN VEHICLE IS DRIVEN
| Effect/Inoperative Function when Necessary Procedure not Performed | Necessary Procedure | Link |
|---|---|---|
| Front Camera System | Drive the vehicle straight ahead at 15 km/h (9 mph) or more for 1 second or more. | Refer to INITIALIZATION [11/2022 - ] |
LEARNING COMPLETES WHEN VEHICLE IS OPERATED NORMALLY
| Effect/Inoperative Function when Necessary Procedure not Performed | Necessary Procedure | Link |
|---|---|---|
Power Door Lock Control System
|
Perform door unlock operation with door control switch or electrical key transmitter sub-assembly switch. | Refer to INITIALIZATION [11/2022 - ] |
*1: for Hatchback