Confirmation Driving Pattern

HINT: 

• After repairs have been completed, clear the DTCs and then check that the vehicle has returned to normal by performing the following All Readiness check procedure.
• When clearing the permanent DTCs, refer to the Clear Permanent DTC procedure.

  Refer to DTC CHECK / CLEAR [03/2023 - ]

1. Clear the DTCs (even if no DTCs are stored, perform the clear DTC procedure).
2. Turn the ignition switch off and wait for 2 minutes or more.
3. w/ Sequential Shift:
   1. Wait with the shift lever in each position (P, R, N or D) for 2 seconds or more each with the ignition switch ON. [*1]
   2. Wait for 2 seconds or more with the shift lever in M. [*2]

      HINT: 

      [*1] and [*2]: Normal judgment procedure.

      The normal judgment procedure is used to complete DTC judgment and also used when clearing permanent DTCs.

4. w/o Sequential Shift:
   1. Wait with the shift lever in each position (P, R, N, D or B) for 2 seconds or more each with the ignition switch ON. [*1]

      HINT: 

      [*1]: Normal judgment procedure.

      The normal judgment procedure is used to complete DTC judgment and also used when clearing permanent DTCs.

5. Enter the following menus: Powertrain / Engine / Utility / All Readiness.
6. Input the DTC: P0705-62.
7. Check the DTC judgment result.

   GTS Display	Description
   NORMAL	DTC judgment completed System normal
   ABNORMAL	DTC judgment completed System abnormal
   INCOMPLETE	DTC judgment not completed Perform driving pattern after confirming DTC enabling conditions
   N/A	Unable to perform DTC judgment Number of DTCs which do not fulfill DTC preconditions has reached ECU memory limit

   HINT: 

   • If the judgment result shows NORMAL, the system is normal.
   • If the judgment result shows ABNORMAL, the system has a malfunction.
   • If the judgment result shows INCOMPLETE or N/A, perform the normal judgment procedure again.