Power Source Circuit [09/2022 - 11/2022]: Procedure
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2025 Toyota GR Corolla, 2025 Toyota Corolla, 2024 Toyota GR Corolla, 2024 Toyota Corolla, and 2023 Toyota GR Corolla. However, it is still accessible from the selected car via links, so may be relevant.
- CHECK HARNESS AND CONNECTOR (POWER SOURCE CIRCUIT)
- Disconnect the I4 combination meter assembly connector.
- Measure the voltage according to the value(s) in the table below.
*a Front view of wire harness connector
(to Combination Meter Assembly)*1 for TMC Made *2 for TMMC Made Standard Voltage (for TMC Made)
Tester Connection Condition Specified Condition I4-5 (B) - Body ground Ignition switch off 11 to 14 V I4-6 (IG+) - Body ground Ignition switch off Below 1 V I4-6 (IG+) - Body ground Ignition switch ON 11 to 14 V Standard Voltage (for TMMMS Made)
Tester Connection Condition Specified Condition I4-22 (B) - Body ground Ignition switch off 11 to 14 V I4-38 (IG+) - Body ground Ignition switch off Below 1 V I4-38 (IG+) - Body ground Ignition switch ON 11 to 14 V Result
Proceed to OK NG
Result:
NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
Result:
OK
See step 2
- CHECK HARNESS AND CONNECTOR (COMBINATION METER ASSEMBLY - BODY GROUND)
- Measure the resistance according to the value(s) in the table below.
Standard Resistance (for TMC Made)
Tester Connection Condition Specified Condition I4-1 (EP) - Body ground Always Below 1 Ω I4-2 (ES) - Body ground Always Below 1 Ω Standard Resistance (for TMMMS Made)
Tester Connection Condition Specified Condition I4-19 (EP) - Body ground Always Below 1 Ω I4-23 (ES) - Body ground Always Below 1 Ω Result
Proceed to OK NG
Result:
OK
REPLACE COMBINATION METER ASSEMBLY
Refer to REMOVAL [09/2022 - 11/2022]
Result:
NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
- Measure the resistance according to the value(s) in the table below.