DTC B1511-87: Lost Communication with Meter Gigabit Video Interface Missing Message [09/2024 - ]: Procedure
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2025 Toyota GR Corolla, 2025 Toyota Corolla, 2024 Toyota GR Corolla, 2024 Toyota Corolla, and 2023 Toyota GR Corolla. However, it is still accessible from the selected car via links, so may be relevant.
- CHECK HARNESS AND CONNECTOR (METER MIRROR SUB-ASSEMBLY - COMBINATION METER ASSEMBLY)
- Disconnect the I247 meter mirror sub-assembly connector.
- Disconnect the I248 combination meter assembly connector.
- Measure the resistance according to the value(s) in the table below.
Standard Resistance
Tester Connection Condition Specified Condition I248-1 (MGV+) - I247-2 (HGV+) Always Below 1 Ω I248-2 (MGV-) - I247-1 (HGV-) Always Below 1 Ω I248-3 (MGVG) - I247-3 (HGVG) Always Below 1 Ω I248-1 (MGV+) or I247-2 (HGV+) - Body ground Always 10 kΩ or higher I248-2 (MGV-) or I247-1 (HGV-) - Body ground Always 10 kΩ or higher Result
Proceed to OK NG
Result:
NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
Result:
OK
See step 2
- REPLACE METER MIRROR SUB-ASSEMBLY
- Replace the meter mirror sub-assembly with a new or known good one.
HINT:
Refer to REMOVAL [09/2024 - ]
Result
Proceed to NEXT
Result:
NEXT
See step 3
- Replace the meter mirror sub-assembly with a new or known good one.
- CLEAR DTC
Result:
NEXT
See step 4
- CHECK FOR DTC
- Check for DTCs.
Body Electrical > Combination Meter > Trouble Codes
Result
Result Proceed to DTC B1511-87 is not output A DTC B1511-87 is output B
Result:
A
END (METER MIRROR SUB-ASSEMBLY IS DEFECTIVE)
Result:
B
REPLACE COMBINATION METER ASSEMBLY
Refer to REMOVAL [09/2024 - ]
- Check for DTCs.