LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2020 >> Corolla L >> Repair and Diagnosis >> External Pages >> Different car >> Section 316 (Hybrid Transaxle System (Pa10) - Service Information) >> Pattern Select Switch >> Inspection [09/2022 - ] >> Procedure

Inspection [09/2022 - ]: Procedure

WARNING: This page is about a different car, the 2025 Toyota Corolla, 2024 Toyota Corolla, and 2023 Toyota Corolla. However, it is still accessible from the selected car via links, so may be relevant.
  1. INSPECT COMBINATION SWITCH ASSEMBLY 
    1. Inspect the DRIVE MODE switch (for Push Switch Type):
      1. Measure the resistance according to the value(s) in the table below.
        GTY1113981Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
        *a Component without harness connected
        (Combination Switch Assembly)

        Standard Resistance

        Tester Connection Condition Specified Condition
        6 (DRV) - 5 (E) Pressed Below 50 Ω
        Not pressed 10 kΩ or higher

        If the result is not as specified, replace the combination switch assembly.

    2. Inspect the DRIVE MODE switch (except Push Switch Type):
      1. Measure the resistance according to the value(s) in the table below.
        GTY1113278Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
        *a Component without harness connected
        (Combination Switch Assembly)
        "DRIVE +" Side
        "DRIVE -" Side

        Standard Resistance

        Tester Connection Condition Specified Condition
        7 (SEL) - 5 (E) Pushed and held at "DRIVE +" side Below 50 Ω
        Released (neutral position) 10 kΩ or higher
        6 (E) - 5 (E) Pushed and held at "DRIVE -" side Below 50 Ω
        Released (neutral position) 10 kΩ or higher

        If the result is not as specified, replace the combination switch assembly.

    3. Inspect the illumination:
      1. Apply auxiliary battery voltage between the terminals of the switch and check the illumination condition of the combination switch assembly.
        GTY850850Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
        *a Component without harness connected
        (Combination Switch Assembly)

        Standard

        Measurement Condition Specified Condition
        Auxiliary battery positive (+) → 4 (ILL+) Illuminates
        Auxiliary battery negative (-) → 1 (ILL-)

        If the result is not as specified, replace combination switch assembly.

scientia non olet · About LEMON Manuals