Customize Parameters [09/2022 - 08/2023]
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2025 Toyota GR Corolla, 2025 Toyota Corolla, 2024 Toyota GR Corolla, 2024 Toyota Corolla, and 2023 Toyota GR Corolla. However, it is still accessible from the selected car via links, so may be relevant.
- CUSTOMIZE METER / GAUGE SYSTEM NOTE:
- When the customer requests a change in a function, first make sure that the function can be customized.
- Be sure to make a note of the current settings before customizing.
- When troubleshooting a function, first make sure that the function is set to the default setting.
- Customizing with the GTS
- Select the setting by referring to the table below.
HINT:
Depending on the specifications of the vehicle, some items may not be displayed.
Warning
Tester Display Description Default Setting ECU Flasher Sound Volume Adjust Function to change the turn signal flasher buzzer sound volume Medium $02:Large, $00:Medium, $01:Small Combination meter assembly Display
Tester Display Description Default Setting ECU ODO Display Time After IG OFF Adjust Function to change the trip result display time after the ignition switch is turned off 30s $00:30s, $01:60s, $02:600s, $03:OFF Combination meter assembly
- Select the setting by referring to the table below.
- Customizing with the multi-information display
- Select the settings tab on the multi-information display.
- Select the setting by referring to the table below.NOTE:
- When the cable is disconnected from the negative (-) auxiliary battery terminal, some of the settings will be reset. Therefore, it is necessary to make a note of each set value before disconnecting the cable.
- As some values cannot be selected when the vehicle is being driven, perform the procedure with the vehicle stopped.
HINT:
Depending on the specifications of the vehicle, some items may not be displayed.
ADJUST METER BRIGHTNESSDisplay Description Setting ECU Functions Brightness setting for meter - Combination meter assembly LDADisplay Description Setting ECU LDA Lane departure alert system setting ON/OFF Forward recognition camera Low Speed Range Assist Low Speed Range Assist setting ON/OFF Alert Options Lane departure alert method setting Steering vibration/buzzer/OFF Alert Timing Lane departure alert timing level setting 1/2 PCSDisplay Description Setting ECU Warning timing Change Warning Timing 1/2/3 Forward recognition camera Warning buzzer Warning buzzer ON/OFF ON/OFF PCS Pre-collision system setting ON/OFF BSMDisplay Description Setting ECU Functions Blind spot monitor system setting ON/OFF Blind spot monitor sensor LH (B) Support timing Change Support Timing 1/2/3 Brightness Outer rear view mirror indicator brightness level setting 1/2 RCTADisplay Description Setting ECU Functions RCTA function setting ON/OFF Blind spot monitor sensor LH (B) Volume RCTA buzzer (blind spot monitor buzzer) volume setting 1/2/3 SEADisplay Description Setting ECU Functions Safe Exit Assist system setting ON/OFF Blind spot monitor sensor LH (B) Sensitivity Change Sensitivity 1/2/3 Mirror indicate Door mirror indicator setting ON/OFF RSADisplay Description Setting ECU Functions Road sign assist system setting ON/OFF Forward recognition camera Notification Method Above Speed Limit Excess speed notification method setting No Notification/Only Visual/Visual & Audio Overtaking No overtaking notification method setting No Notification/Only Visual/Visual & Audio Others Others traffic sign notification method setting No Notification/Only Visual/Visual & Audio Notification Level Excess speed notification level setting 10 km/h (5 MPH), 5 km/h (3 MPH), 2 km/h (1 MPH) VEHICLE SETTINGSDisplay Description Setting ECU DRCC/Speed Limiter DRCC (RSA) System ON/OFF ON/OFF ECM Speed Limit Offset Speed Limit Offset +/- +/-1, +/-5, +/-10 Overtake Prevention System ON/OFF ON/OFF Acceleration Setting Acceleration Setting Low/Mid/High 1/2/3 Speed Setting (Push) Speed Setting (Push) +/-1, +/-5, +/-10 +/-1, +/-5, +/-10 Speed setting (Hold) Speed Setting (Hold) +/-1, +/-5, +/-10 +/-1, +/-5, +/-10 Guide message System ON/OFF ON/OFF Curve Speed Reduction Curve Speed Reduction System OFF/Low/Mid/High 1/2/3 TPWS setting Tire Set Switching Register replaced valve / ID - Tire Pressure Warning ECU and Receiver Tire Rotation Reset tire location Yes/No Tire Pressure Setting Set tire warning pressure Setting by specified pressure/setting by current pressure Pressure unit setting Change display units kPa/psi/bar Scheduled Maintenance Scheduled maintenance data reset Yes/No ECM METER SETTINGSDisplay Description Setting ECU Language Display language setting * Related ECUs Units Display units setting * Meter Type Meter Type setting 3 Type Combination meter assembly REV Indicator REV Indicator Displayed REV indicator display item setting ON/OFF Rev Setting Displayed REV indicator display item setting 2000rpm to 7200rpm REV Peak Displayed REV peak display item setting ON/OFF Eco driving indicator light Eco driving indicator light display setting ON/OFF Fuel Economy Displayed fuel economy display item setting Trip Average/Total Average Drive Information Distance Displayed drive information display item setting Average Speed/Distance/Total Time Total Time Displayed drive information display item setting Average Speed/Distance/Total Time TRIP A Items Distance Current trip result display setting Average Speed/Distance/Total Time Average Speed Current trip result display setting Average Speed/Distance/Total Time TRIP B Items Distance Current trip result display setting Average Speed/Distance/Total Time Average Speed Current trip result display setting Average Speed/Distance/Total Time Pop-Up Display TbT Navigation Interrupt display setting ON/OFF Telephone Interrupt display setting ON/OFF Audio Operation Interrupt display setting ON/OFF Volume Operation Interrupt display setting ON/OFF Voice Control Interrupt display setting ON/OFF Default Settings Reset the combination meter settings to the default setting Yes/No Related ECUs - *: Varies according to the vehicle specification.