Inspection [04/2018 - ]: Procedure

WARNING: This page is about a different variant/trim than selected.

INSPECT FLOW SHUTTING VALVE (WATER BY-PASS HOSE ASSEMBLY)

Measure the resistance according to the value(s) in the table below.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

*a	Component without harness connected (Flow Shutting Valve (Water By-pass Hose Assembly))

Standard Resistance

Tester Connection	Condition	Specified Condition
1 - 2	20°C (68°F)	22 to 28 Ω

If the result is not as specified, replace the flow shutting valve (water by-pass hose assembly).