Jam Protection Function does not Operate [04/2018 - ]: Procedure

1. Initialize the power window regulator motor assembly (applicable location).

   Refer to INITIALIZATION [04/2018 - ]

   Result

   Proceed to
   NEXT

Result: 

NEXT 

See step  2

1. Check if the power window auto up and down functions operate normally.

   Refer to OPERATION CHECK [04/2018 - ]

   OK

   Auto up and down functions are normal.

   Result

   Proceed to
   OK
   NG

Result: 

NG 

GO TO OTHER PROBLEM (Proceed to Problem Symptoms Table). Refer to  PROBLEM SYMPTOMS TABLE [04/2018 - ] 

Result: 

OK 

See step  3

1. Check if the jam protection function operates normally for the applicable power window.

   HINT: 

   The jam protection function will not operate within 4 mm (0.157 in.) of the fully closed position.

   OK

   Jam protection function operates normally.

   Result

   Result	Proceed to
   OK	A
   NG (Driver door power window)	B
   NG (Front passenger door power window)
   NG (Rear LH door power window)	C
   NG (Rear RH door power window)

Result: 

A 

END (PROBLEM DUE TO INITIALIZATION FAILURE) 

Result: 

B 

REPLACE POWER WINDOW REGULATOR MOTOR ASSEMBLY (for Driver Door or Front Passenger Door). Refer to  REMOVAL [04/2018 - 08/2020]  , or refer to  REMOVAL [08/2020 - 08/2021]  , or refer to  REMOVAL [08/2021 - ] 

Result: 

C 

REPLACE POWER WINDOW REGULATOR MOTOR ASSEMBLY (for Rear LH Door or Rear RH Door). Refer to  REMOVAL [04/2018 - 08/2020]  , or refer to  REMOVAL [08/2020 - 08/2021]  , or refer to  REMOVAL [08/2021 - ]