DTC B2313: Glass Position Initialization Incomplete [04/2018 - ]: Procedure

1. Turn the power switch on (IG).
2. Initialize the power window regulator motor assembly.

   Refer to INITIALIZATION [04/2018 - ]

   HINT: 

   Initialize the power window regulator motor assembly that has DTC B2313 stored in its ECU.

   Result

   Proceed to
   NEXT

Result: 

NEXT 

See step  2

1. Turn the power switch off.
2. Wait for at least 10 seconds, and then turn the power switch on (IG).
3. Check for DTCs.

   Body Electrical > D-Door Motor > Trouble Codes 

   Body Electrical > P-Door Motor > Trouble Codes 

   Body Electrical > RL-Door Motor > Trouble Codes 

   Body Electrical > RR-Door Motor > Trouble Codes 

   HINT: 

   Check for DTCs for the power window regulator motor assembly that had DTC B2313 stored in its ECU.

   OK

   DTC B2313 is not output.

   Result

   Result	Proceed to
   OK	A
   NG (Driver door power window)	B
   NG (Front passenger door power window)
   NG (Rear LH door power window)	C
   NG (Rear RH door power window)

Result: 

A 

END (POWER WINDOW CONTROL SYSTEM HAS NOT BEEN INITIALIZED) 

Result: 

B 

REPLACE POWER WINDOW REGULATOR MOTOR ASSEMBLY (for Driver Door or Front Passenger Door). Refer to  REMOVAL [04/2018 - 08/2020]  , or refer to  REMOVAL [08/2020 - 08/2021]  , or refer to  REMOVAL [08/2021 - ] 

Result: 

C 

REPLACE POWER WINDOW REGULATOR MOTOR ASSEMBLY (for Rear LH Door or Rear RH Door). Refer to  REMOVAL [04/2018 - 08/2020]  , or refer to  REMOVAL [08/2020 - 08/2021]  , or refer to  REMOVAL [08/2021 - ]