Caution / Notice / Hint

WARNING: This page is about a different variant/trim than selected.

NOTE:

DTC B2312 is stored in the multiplex network master switch assembly and in each power window regulator motor assembly.
If a power window regulator motor assembly has been replaced with a new one, initialize the power window control system.
Refer to INITIALIZATION [04/2018 - ]
Inspect the fuses for circuits related to this system before performing the following procedure.
The power window control system uses the LIN communication system. Inspect the communication function by following How to Proceed with Troubleshooting. Troubleshoot the power window control system after confirming that the communication system is functioning properly.
Refer to HOW TO PROCEED WITH TROUBLESHOOTING [04/2018 - ]

HINT:

If DTC B2312 is not output again after the DTC has been cleared, the DTC was stored due to the switch being held in the same position continuously.