DTC B2275: STSW Monitor Malfunction [04/2018 - ]: Procedure

1. Turn the power switch on (IG) and wait 25 seconds.
2. Using the Techstream, check for certification ECU (smart key ECU assembly) DTCs.

   Body Electrical > Power Source Control > Trouble Codes 

   OK

   DTC B2285 is not output simultaneously.

   Result

   Proceed to
   OK
   NG

Result: 

NG 

GO TO DTC B2285. Refer to  DTC B2285: Steering Lock Position Signal Circuit Malfunction [04/2018 - 08/2020]  , or refer to  DTC B2285: Steering Lock Position Signal Circuit Malfunction [08/2020 - ]  

Result: 

OK 

See step  2

1. Disconnect the G40 certification ECU (smart key ECU assembly) connector.
2. Disconnect the G46 hybrid vehicle control ECU connector.
3. Measure the resistance according to the value(s) in the table below.

   Standard Resistance

   Tester Connection	Condition	Specified Condition
   G40-27 (ST2) - G46-9 (ST2)	Always	Below 1 Ω
   G40-27 (ST2) or G46-9 (ST2) - Other terminals and body ground	Always	10 kΩ or higher

   Result

   Proceed to
   OK
   NG

Result: 

NG 

REPAIR OR REPLACE HARNESS OR CONNECTOR 

Result: 

OK 

See step  3

1. Reconnect the G40 certification ECU (smart key ECU assembly) connector.
2. Reconnect the G46 hybrid vehicle control ECU connector.
3. Measure the voltage according to the value(s) in the table below.

   Standard Voltage

   Tester Connection	Condition	Specified Condition
   G40-27 (ST2) - Body ground	With the brake pedal depressed, the power switch is pressed and held → After approx. 3 sec. has elapsed, the power switch is released	8.5 V or higher → 1 V or less

   Result

   Proceed to
   OK
   NG

Result: 

OK 

REPLACE HYBRID VEHICLE CONTROL ECU. Refer to  REMOVAL [04/2018 - 08/2021]  , or refer to  REMOVAL [08/2021 - ] 

Result: 

NG 

REPLACE CERTIFICATION ECU (SMART KEY ECU ASSEMBLY). Refer to  REMOVAL [04/2018 - 08/2021]  , or refer to  REMOVAL [08/2021 - ]