Vehicle Speed Signal Circuit between Navigation ECU and Combination Meter [04/2018 - ]: Description

WARNING: This page is about a different variant/trim than selected.

The navigation ECU receives a vehicle speed signal from the combination meter assembly.

HINT:

A voltage of 12 V or 5 V is output from each ECU and then input to the combination meter assembly. The signal is changed to a pulse signal at the transistor in the combination meter assembly. Each ECU controls its respective systems based on this pulse signal.
If a short occurs in any of the ECUs or in the wire harness connected to an ECU, all systems in the following diagram will not operate normally.