Reverse Signal Circuit [04/2018 - ]: Procedure
WARNING: This page is about a different variant/trim than selected.
- CHECK BACK-UP LIGHT
- Move the shift lever to R and check if the back-up lights come on.
OK
The back-up lights come on.
Result
Proceed to OK NG
Result:
NG
GO TO LIGHTING SYSTEM
w/ Cornering Light: Refer to HOW TO PROCEED WITH TROUBLESHOOTING [04/2018 - 08/2021] , or refer to HOW TO PROCEED WITH TROUBLESHOOTING [08/2021 - ]
w/o Cornering Light: Refer to HOW TO PROCEED WITH TROUBLESHOOTING [04/2018 - 08/2021] , or refer to HOW TO PROCEED WITH TROUBLESHOOTING [08/2021 - ]
Result:
OK
See step 2
- Move the shift lever to R and check if the back-up lights come on.
- CHECK HARNESS AND CONNECTOR (REVERSE SIGNAL)
- Disconnect the G3 radio and display receiver assembly connector.
- Measure the voltage according to the value(s) in the table below.
Standard Voltage
Tester Connection Condition Specified Condition G3-28 (REV) - Body ground Power switch on (IG)
Shift lever in R11 to 14 V G3-28 (REV) - Body ground Power switch on (IG)
Shift lever not in RBelow 1 V Result
Proceed to OK NG
Result:
OK
PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE. Refer to PROBLEM SYMPTOMS TABLE [04/2018 - 08/2020] , or refer to PROBLEM SYMPTOMS TABLE [08/2020 - ]
Result:
NG
REPAIR OR REPLACE HARNESS OR CONNECTOR