"CHK" message(s) are displayed on the SIGNAL CHECK screen. [04/2018 - ]: Description
WARNING: This page is about a different variant/trim than selected.
On the SIGNAL CHECK screen, it is possible to check if the signals sent to the parking assist ECU are normal.
Refer to DTC CHECK / CLEAR [04/2018 - ]
HINT:
- On the SIGNAL CHECK screen, "OK" (blue) is displayed for items with a normal inspection result or input state.
- On the SIGNAL CHECK screen, "CHK" (red) is displayed for items with an abnormal inspection result or input state.
- Displayed items may differ depending on vehicle specifications.
| Item | Signal Input Method | Detail | DTC Output when Abnormal Result is Displayed | Signal Receiver |
|---|---|---|---|---|
| CAN | CAN communication | CAN communication signal | DTC is output | Related ECUs |
| SHIFT | Vehicle wire harness | Shift position switch signal | DTC is not output | BKUP LP relay |
| CAMERA SW | Vehicle wire harness | Panoramic view monitor switch signal input state | DTC is not output | Panoramic View Monitor Switch |