DTC C2A6A: Back Camera Response Malfunction [04/2018 - ]: Procedure
WARNING: This page is about a different variant/trim than selected.
- CHECK FOR DTC
- Clear the DTCs.
Chassis > Panoramic View Monitor > Clear DTCs
- Check for DTCs.
Chassis > Panoramic View Monitor > Trouble Codes
OK
DTC C2A6A is not output.
Result
Proceed to OK NG
Result:
OK
USE SIMULATION METHOD TO CHECK. Refer to HOW TO PROCEED WITH TROUBLESHOOTING [04/2018 - ]
Result:
NG
See step 2
- Clear the DTCs.
- REPLACE TELEVISION CAMERA ASSEMBLY
- Replace the television camera assembly with a new or normally functioning one.
Refer to REMOVAL [04/2018 - ]
Result
Proceed to NEXT
Result:
NEXT
See step 3
- Replace the television camera assembly with a new or normally functioning one.
- CHECK FOR DTC
- Clear the DTCs.
Chassis > Panoramic View Monitor > Clear DTCs
- Check for DTCs.
Chassis > Panoramic View Monitor > Trouble Codes
OK
DTC C2A6A is not output.
Result
Proceed to OK NG
Result:
OK
END (TELEVISION CAMERA ASSEMBLY IS DEFECTIVE)
Result:
NG
REPLACE PARKING ASSIST ECU. Refer to REMOVAL [04/2018 - 08/2021] , or refer to REMOVAL [08/2021 - ]
- Clear the DTCs.