Installation [04/2018 - 08/2019]: Procedure
WARNING: This page is about a different variant/trim than selected.
- INSTALL OIL PRESSURE SENSOR (OIL PRESSURE SENDER GAUGE ASSEMBLY)
- Apply adhesive to 2 or 3 threads of the oil pressure sensor (oil pressure sender gauge assembly).
Adhesive
Toyota Genuine Adhesive 1344, Three Bond 1344 or equivalent
*a Adhesive *b Oil Inlet Port NOTE:- Do not apply adhesive to the oil inlet port of the oil pressure sensor (oil pressure sender gauge assembly).
- Install the oil pressure sensor (oil pressure sender gauge assembly) within 3 minutes of applying adhesive.
- Using a 27 mm deep socket wrench, install the oil pressure sensor (oil pressure sender gauge assembly) to the cylinder block sub-assembly.
Torque: 15 N*m (153 kgf*cm, 11 ft.*lbf)
- Connect the oil pressure sensor (oil pressure sender gauge assembly) connector.
- Apply adhesive to 2 or 3 threads of the oil pressure sensor (oil pressure sender gauge assembly).
- INSPECT FOR ENGINE OIL LEAK
Refer to PROCEDURE - Step 6
- INSTALL NO. 2 ENGINE UNDER COVER ASSEMBLY
Refer to PROCEDURE - Step 41
- INSTALL NO. 1 ENGINE UNDER COVER
Refer to PROCEDURE - Step 42
- INSTALL FRONT WHEEL OPENING EXTENSION PAD LH
Refer to PROCEDURE - Step 43
- INSTALL FRONT WHEEL OPENING EXTENSION PAD RH
Refer to PROCEDURE - Step 44