LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2020 >> Avalon Limited >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 59 (Engine Lubrication System (Service Information) [A25A-FXS]) >> Oil Pan And Oil Level Sensor >> Installation [04/2018 - ] >> Procedure

Installation [04/2018 - ]: Procedure

WARNING: This page is about a different variant/trim than selected.
  1. INSTALL ENGINE OIL LEVEL SENSOR 
    1. Using an 8 mm socket wrench, install the engine oil level sensor to the engine balancer assembly with the 2 bolts.

      Torque: 10 N*m (102 kgf*cm, 7 ft.*lbf) 

    2. Install a new clip to the engine oil level sensor.
    3. Connect the engine oil level sensor connector.
  2. INSTALL NO. 2 OIL PAN SUB-ASSEMBLY 

    Refer to PROCEDURE - Step 12 [04/2018 - 08/2019] , or refer to PROCEDURE - Step 12 [08/2019 - 08/2021] , or refer to PROCEDURE - Step 12 [08/2021 - ]

  3. ADD ENGINE OIL 

    Refer to PROCEDURE - Step 5 [04/2018 - 08/2021] , or refer to PROCEDURE - Step 5 [08/2021 - ]

  4. INSPECT FOR ENGINE OIL LEAK 

    Refer to PROCEDURE - Step 6 [04/2018 - 08/2021] , or refer to PROCEDURE - Step 6 [08/2021 - ]

  5. CHECK ENGINE OIL LEVEL 

    Refer to PROCEDURE - Step 1

  6. INSTALL NO. 2 ENGINE UNDER COVER ASSEMBLY 

    Refer to PROCEDURE - Step 41

  7. INSTALL NO. 1 ENGINE UNDER COVER 

    Refer to PROCEDURE - Step 42

  8. INSTALL FRONT WHEEL OPENING EXTENSION PAD LH 

    Refer to PROCEDURE - Step 43

  9. INSTALL FRONT WHEEL OPENING EXTENSION PAD RH 

    Refer to PROCEDURE - Step 44

scientia non olet · About LEMON Manuals