DTC B1610: Front Airbag Sensor (RH) [04/2018 -]: Procedure

1. Turn the power switch off.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   *1	Front Airbag Sensor LH
   *2	Airbag ECU Assembly

2. Disconnect the cable from the negative (-) auxiliary battery terminal.
   WARNING:

   Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.

3. Interchange the front airbag sensor RH with LH and connect the connectors.
4. Connect the cable to the negative (-) auxiliary battery terminal.
5. Turn the power switch on (IG), and wait for at least 60 seconds.
6. Clear the DTCs stored in memory.

   Body Electrical > SRS Airbag > Clear DTCs 

7. Turn the power switch off.
8. Turn the power switch on (IG), and wait for at least 60 seconds.
9. Check for DTCs.

   Body Electrical > SRS Airbag > Trouble Codes 

   HINT: 

   Codes other than DTCs B1610 and B1615 may be output at this time, but they are not related to this check.

   Result

   Result	Proceed to
   DTCs B1610 and B1615 are not output.	A
   DTC B1610 is output.	B
   DTC B1615 is output.	C

10. Turn the power switch off.
11. Disconnect the cable from the negative (-) auxiliary battery terminal.
    WARNING:

    Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.

12. Return the front airbag sensor RH and LH to their original positions and connect the connectors.

Result: 

A 

USE SIMULATION METHOD TO CHECK. Refer to  HOW TO PROCEED WITH TROUBLESHOOTING [04/2018 -] 

Result: 

B 

REPLACE AIRBAG ECU ASSEMBLY. Refer to  REMOVAL [04/2018 - 08/2020]  , or refer to  REMOVAL [08/2020 - 08/2021]  , or refer to  REMOVAL [08/2021 -] 

Result: 

C 

REPLACE FRONT AIRBAG SENSOR RH. Refer to  REMOVAL [04/2018 - 08/2020]  , or refer to  REMOVAL [08/2020 - 08/2021]  , or refer to  REMOVAL [08/2021 -]