Removal [04/2018 - 08/2021]: Procedure

WARNING: This page is about a different variant/trim than selected.

REMOVE INVERTER WITH CONVERTER ASSEMBLY
Refer to REMOVAL [04/2018 - 08/2020] , or refer to REMOVAL [08/2020 - 08/2021]

REMOVE MOTOR CABLE

WARNING:

Be sure to wear insulated gloves.

Remove the 2 bolts and connector cover from the hybrid vehicle transaxle assembly.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Disengage the 2 claws to remove the terminal cap from the hybrid vehicle transaxle assembly.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Using an insulated tool, remove the 6 bolts and motor cable from the hybrid vehicle transaxle assembly.

*a	Waterproof Seal

NOTE:

Keep the motor cable terminals and their installation area free from foreign matter, water, etc.
Do not touch the waterproof seal or terminals of the motor cable.
Cover the hole where the motor cable was installed with tape or equivalent (non-residue type) to prevent entry of foreign matter.