LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2020 >> Avalon Limited >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 41 (Engine Mechanical (Service Information) [A25A-FXS] (1 Of 2)) >> Front Crankshaft Oil Seal >> Removal [08/2021 - ] >> Procedure

Removal [08/2021 - ]: Procedure

WARNING: This page is about a different variant/trim than selected.
  1. REMOVE ENGINE ASSEMBLY WITH TRANSAXLE 

    Refer to REMOVAL [08/2021 - ] 

  2. REMOVE CRANKSHAFT PULLEY ASSEMBLY 

    Refer to PROCEDURE - Step 19

  3. REMOVE TIMING CHAIN COVER OIL SEAL 
    1. Using a screwdriver with its tip wrapped with protective tape, pry out the timing chain case oil seal.
      GTY745111Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *a Protective Tape
      NOTE:

      After removal, check the crankshaft for damage. If it is damaged, smooth the surface with 400-grit sandpaper.

scientia non olet · About LEMON Manuals