LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2020 >> Avalon Limited >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 39 (Emission Control System (Service Information) [A25A-FXS]) >> Purge Valve >> Installation [04/2018 -] >> Procedure

Installation [04/2018 -]: Procedure

WARNING: This page is about a different variant/trim than selected.
  1. INSTALL PURGE VALVE (PURGE VSV) 
    1. Install the purge valve (purge VSV) to the intake manifold with the bolt.

      Torque: 10 N*m (102 kgf*cm, 7 ft.*lbf) 

      GTY764037Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *1 No. 1 Fuel Vapor Feed Hose
      *2 No. 2 Fuel Vapor Feed Hose
      *3 Purge Valve (Purge VSV)
    2. Connect the No. 2 fuel vapor feed hose to the purge valve (purge VSV).
    3. Connect the No. 1 fuel vapor feed hose to the purge valve (purge VSV).
    4. Connect the purge valve (purge VSV) connector.
scientia non olet · About LEMON Manuals