Caution / Notice / Hint
WARNING: This page is about a different variant/trim than selected.
The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during fuel tank pressure sensor (vapor pressure sensor assembly) removal/installation are shown below.
NECESSARY PROCEDURES AFTER PARTS REMOVED/INSTALLED/REPLACED
| Replaced Part or Performed Procedure | Necessary Procedure | Effect/Inoperative Function when Necessary Procedure not Performed | Link |
|---|---|---|---|
| Disconnect cable from negative (-) auxiliary battery terminal | Perform steering sensor zero point calibration | Lane departure alert system (w/ Steering Control) | Refer to INITIALIZATION [04/2018 - 08/2021] |
| Pre-collision system | |||
| Intelligent clearance sonar system* | |||
| Lighting system (w/ AFS) (EXT) | |||
| Memorize steering angle neutral point | Parking assist monitor system | Refer to INITIALIZATION [04/2018 -] | |
| Panoramic view monitor system | Refer to INITIALIZATION [04/2018 -] |
*: When performing learning using the Techstream.