Installation [04/2018 -]: Procedure
WARNING: This page is about a different variant/trim than selected.
- INSTALL FUEL TANK PRESSURE SENSOR (VAPOR PRESSURE SENSOR ASSEMBLY)
- Push the fuel tank pressure sensor (vapor pressure sensor assembly) onto the fuel tank assembly, then install the tube joint clip.NOTE:
- Check that there are no scratches or foreign matter around the connecting parts of the fuel tank pressure sensor (vapor pressure sensor assembly) and fuel suction plate sub-assembly before performing this work.
- Check that the fuel suction plate sub-assembly is securely inserted to the end of the fuel tank pressure sensor (vapor pressure sensor assembly).
- Check that the tube joint clip is on the collar of the fuel tank pressure sensor (vapor pressure sensor assembly).
- After installing the tube joint clip, check that the fuel tank pressure sensor (vapor pressure sensor assembly) cannot be pulled out.
*1 Tube Joint Clip *a O-ring *b Collar
- Push the fuel tank pressure sensor (vapor pressure sensor assembly) onto the fuel tank assembly, then install the tube joint clip.
- INSTALL REAR FLOOR SERVICE HOLE COVER
Refer to PROCEDURE - Step 6
- INSTALL REAR SEAT ASSEMBLY
Refer to INSTALLATION [04/2018 - 08/2020] , or refer to INSTALLATION [08/2020 -]