Caution / Notice / Hint
WARNING: This page is about a different variant/trim than selected.
The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during EGR valve assembly removal/installation are shown below.
NECESSARY PROCEDURES AFTER PARTS REMOVED/INSTALLED/REPLACED
| Replaced Part or Performed Procedure | Necessary Procedures | Effect/Inoperative Function when Necessary Procedure not Performed | Link |
|---|---|---|---|
| Auxiliary battery terminal is disconnected/reconnected | Perform steering sensor zero point calibration | Lane Tracing Assist System | Refer to INITIALIZATION [08/2021 -] |
| Pre-collision system | |||
| Intelligent clearance sonar system* | |||
| Lighting System (for HV Model with Cornering Light) | |||
| Memorize steering angle neutral point | Parking assist monitor system | Refer to INITIALIZATION [04/2018 -] | |
| Panoramic view monitor system | Refer to INITIALIZATION [04/2018 -] | ||
| Replacement of inverter with converter assembly | Resolver learning |
|
Refer to UTILITY [08/2020 -] |
| Replacement of ECM | Perform Vehicle Identification Number (VIN) registration | MIL illuminates | Refer to REGISTRATION [04/2018 -] |
|
Inspection After Repair |
|
Refer to INITIALIZATION [08/2021 -] |
*: When performing learning using the Techstream.
NOTE:
This procedure includes the removal of small-head bolts. Refer to Small-Head Bolts of Basic Repair Hint to identify the small-head bolts.
- After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work.
Refer to PRECAUTION [04/2018 -]
- This procedure includes the removal of small-head bolts. Refer to Small-Head Bolts of Basic Repair Hint to identify the small-head bolts.
Refer to PRECAUTION [04/2018 -]