LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2020 >> Avalon Limited >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 38 (Engine Control System (Service Information) [A25A-FXS]) >> Knock Sensor >> Removal [04/2018 - ] >> Procedure

Removal [04/2018 - ]: Procedure

WARNING: This page is about a different variant/trim than selected.
  1. REMOVE INTAKE MANIFOLD 

    Refer to REMOVAL [04/2018 - 08/2021] , or refer to REMOVAL [08/2021 - ]

  2. REMOVE KNOCK CONTROL SENSOR 
    1. Disconnect the knock control sensor connector.
      GTY762819Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Remove the bolt and knock control sensor from the cylinder block sub-assembly.
      NOTE:

      If the knock control sensor has been struck or dropped, replace it.

scientia non olet · About LEMON Manuals