Installation [04/2018 - ]: Procedure

HINT: 

Perform "Inspection After Repair" after replacing the knock control sensor.

Refer to INITIALIZATION [04/2018 - 08/2019] , or refer to INITIALIZATION [08/2019 - 08/2021] , or refer to INITIALIZATION [08/2021 - ]

1. Install the knock control sensor to the cylinder block sub-assembly with the bolt so that the knock control sensor installation position is as shown in the illustration.

   Torque: 21 N*m (214 kgf*cm, 15 ft.*lbf) 

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   *a	Top
   *b	Right of Vehicle
   *c	15°
   *d	5°

   NOTE:

   • If the knock control sensor has been struck or dropped, replace it.
   • Make sure that the knock control sensor is in the correct position.
2. Connect the knock control sensor connector.

Refer to INSTALLATION [04/2018 - 08/2021] , or refer to INSTALLATION [08/2021 - ]

1. Perform "Inspection After Repair" after replacing the knock control sensor.

   Refer to INITIALIZATION [04/2018 - 08/2019] , or refer to INITIALIZATION [08/2019 - 08/2021] , or refer to INITIALIZATION [08/2021 - ]