Installation [04/2018 - 08/2019]: Procedure

WARNING: This page is about a different variant/trim than selected.

INSTALL ENGINE OIL TEMPERATURE SENSOR

Install a new gasket to the engine oil temperature sensor.

Using SST, install the engine oil temperature sensor to the cylinder block sub-assembly.

SST: 09817-33191

Torque: 19.6 N*m (200 kgf*cm, 14 ft.*lbf)

NOTE:

If the engine oil temperature sensor has been struck or dropped, replace it.

GTY755107

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Connect the engine oil temperature sensor connector.

CHECK ENGINE OIL LEVEL
Refer to PROCEDURE - Step 1
INSPECT FOR ENGINE OIL LEAK
Refer to PROCEDURE - Step 6
INSTALL NO. 2 ENGINE UNDER COVER ASSEMBLY
Refer to PROCEDURE - Step 41
INSTALL NO. 1 ENGINE UNDER COVER
Refer to PROCEDURE - Step 42
INSTALL FRONT WHEEL OPENING EXTENSION PAD LH
Refer to PROCEDURE - Step 43
INSTALL FRONT WHEEL OPENING EXTENSION PAD RH
Refer to PROCEDURE - Step 44