Removal [04/2018 - 08/2021]: Procedure
WARNING: This page is about a different variant/trim than selected.
- DRAIN ENGINE COOLANT (for Engine)
Refer to PROCEDURE - Step 1
- REMOVE COOL AIR INTAKE DUCT SEAL
Refer to PROCEDURE - Step 1
- REMOVE INLET AIR CLEANER ASSEMBLY
Refer to PROCEDURE - Step 5 [04/2018 - 08/2020]
, or refer to PROCEDURE - Step 5 [08/2020 - 08/2021]
- REMOVE NO. 2 ENGINE COOLANT TEMPERATURE SENSOR
- Disconnect the No. 2 engine coolant temperature sensor connector.
 Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
|
- Remove the clip and No. 2 engine coolant temperature sensor from the radiator pipe.
 Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
|
NOTE:
If the No. 2 engine coolant temperature sensor has been struck or dropped, replace it.
- REMOVE INVERTER WITH CONVERTER ASSEMBLY
Refer to REMOVAL [04/2018 - 08/2020]
, or refer to REMOVAL [08/2020 - 08/2021]
- REMOVE ENGINE COOLANT TEMPERATURE SENSOR
- Disconnect the engine coolant temperature sensor connector.
 Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
|
- Remove the clip and engine coolant temperature sensor from the water outlet.
 Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
|
NOTE:
If the engine coolant temperature sensor has been struck or dropped, replace it.