Removal [08/2021 - ]: Procedure
WARNING: This page is about a different variant/trim than selected.
- REMOVE LUGGAGE TRIM SERVICE HOLE COVER
Refer to PROCEDURE - Step 2
- DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL
Refer to PROCEDURE - Step 3
- REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY
Refer to PROCEDURE - Step 18
- REMOVE CAM TIMING CONTROL MOTOR WITH EDU ASSEMBLY
- Disconnect the cam timing control motor with EDU assembly connector.
 Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
|
- Remove the 3 bolts and cam timing control motor with EDU assembly from the No. 2 timing chain cover assembly.
NOTE:
If the cam timing control motor with EDU assembly has been struck or dropped, replace it.
- REMOVE CAM TIMING CONTROL MOTOR O-RING
- Remove the cam timing control motor O-ring from the No. 2 timing chain cover assembly.
 Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
|