Removal [04/2018 - ]: Procedure

Refer to PROCEDURE - Step 1

1. Remove the fuel tank cap assembly.
2. Remove all necessary screws and clips and pull back the rear wheel house liner LH to the extent that the fuel tank filler pipe sub-assembly can be accessed.
3. While holding the fuel tank filler pipe sub-assembly, disengage the claws of the No. 2 fuel tank filler pipe protector and pull the No. 2 fuel tank filler pipe protector off of the fuel tank filler pipe sub-assembly.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   *1	Fuel Tank Filler Pipe Sub-assembly
   *2	No. 2 Fuel Tank Filler Pipe Protector
   *a	Pull up
   *b	Pull off
   *c	Hold