LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2020 >> Avalon Limited >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 35 (Fuel System (Service Information) [A25A-FXS]) >> Fuel Sender Gauge Assembly >> Installation [04/2018 - ] >> Procedure

Installation [04/2018 - ]: Procedure

WARNING: This page is about a different variant/trim than selected.
  1. INSTALL FUEL SENDER GAUGE ASSEMBLY 
    1. for Type A:
      1. Engage the claw to install the fuel sender gauge assembly to the fuel suction tube with pump and gauge assembly.
        NOTE:

        Be careful not to bend the arm of the fuel sender gauge assembly.

      2. Engage the 2 clamps to connect the wire harness to the fuel suction tube with pump and gauge assembly.
        NOTE:
        • Do not damage the wire harness.
        • When engaging each wire harness to the clamp, engage one wire at a time.
      3. Connect the fuel sender gauge assembly connector.
    2. for Type B:
      1. Engage the 2 claws to install the fuel sender gauge assembly to the fuel gauge bracket.
      2. Engage the 2 claws to install the fuel gauge bracket with fuel sender gauge assembly to the fuel suction tube with pump and gauge assembly.
        NOTE:

        Be careful not to bend the arm of the fuel sender gauge assembly.

      3. Engage the 2 clamps to connect the wire harness to the fuel suction tube with pump and gauge assembly.
        NOTE:
        • Do not damage the wire harness.
        • When engaging each wire harness to the clamp, engage one wire at a time.
      4. Connect the fuel sender gauge assembly connector.
  2. INSTALL FUEL SUCTION TUBE WITH PUMP AND GAUGE ASSEMBLY 

    Refer to INSTALLATION [04/2018 - ] 

scientia non olet · About LEMON Manuals