Removal [04/2018 - 08/2021]: Procedure

WARNING: This page is about a different variant/trim than selected.

PRECAUTION
NOTE:
After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work.

Refer to PRECAUTION [04/2018 - ]
DISCHARGE FUEL SYSTEM PRESSURE
Refer to PRECAUTION [04/2018 - ]
REMOVE LUGGAGE TRIM SERVICE HOLE COVER
Refer to PROCEDURE - Step 2 [04/2018 - 08/2019] , or refer to PROCEDURE - Step 2 [08/2019 - 08/2021]
DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL
Refer to PROCEDURE - Step 3 [04/2018 - 08/2019] , or refer to PROCEDURE - Step 3 [08/2019 - 08/2021]
REMOVE THROTTLE BODY WITH MOTOR ASSEMBLY
Refer to REMOVAL [04/2018 - ]
REMOVE EGR VALVE ASSEMBLY
Refer to REMOVAL [04/2018 - 08/2021]
REMOVE NO. 2 WATER BY-PASS PIPE
Refer to PROCEDURE - Step 7
DISCONNECT FUEL TUBE SUB-ASSEMBLY
See step 8
REMOVE NO. 1 FUEL PIPE SUB-ASSEMBLY
See step 9

REMOVE NO. 2 FUEL PRESSURE SENSOR

Disconnect the No. 2 fuel pressure sensor connector.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Using an 8 mm socket wrench, remove the bolt, No. 2 fuel pressure sensor and No. 2 fuel pressure sensor holder from the fuel delivery pipe sub-assembly.

Remove the O-ring from the No. 2 fuel pressure sensor.