Removal [04/2018 - 08/2021]: Procedure

WARNING: This page is about a different variant/trim than selected.

REMOVE FUEL SUCTION TUBE WITH PUMP AND GAUGE ASSEMBLY
Refer to REMOVAL [04/2018 - 08/2021]

REMOVE FUEL MAIN VALVE ASSEMBLY

for Type A:

Remove the clip from the fuel suction tube with pump and gauge assembly.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Using a screwdriver with its tip wrapped with protective tape, remove the fuel main valve assembly from the fuel suction tube with pump and gauge assembly.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

*a	Protective Tape

NOTE:

Pull out the fuel main valve assembly carefully because the O-rings are firmly installed between the fuel main valve assembly and fuel suction tube with pump and gauge assembly.
Do not damage the fuel suction tube with pump and gauge assembly.

Remove the 2 O-rings from the fuel main valve assembly.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

O-ring

for Type B:

Disengage the 2 claws and remove the fuel pressure regulator holder from the fuel suction tube with pump and gauge assembly.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Using a screwdriver with its tip wrapped with protective tape, remove the fuel main valve assembly from the fuel suction tube with pump and gauge assembly.

*a	Protective Tape

NOTE:

Pull out the fuel main valve assembly carefully because the O-ring is firmly installed between the fuel main valve assembly and fuel suction tube with pump and gauge assembly.

Do not damage the fuel suction tube with pump and gauge assembly.

Remove the O-ring from the fuel main valve assembly.

*1	O-ring
*a	Mesh
*b	Mini-clip

NOTE:

Do not remove the mesh and mini-clip from the fuel main valve assembly.