Removal [04/2018 - 08/2021]: Caution/Notice/Hint
WARNING: This page is about a different variant/trim than selected.
The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during direct fuel injector assembly removal/installation are shown below.
NECESSARY PROCEDURES AFTER PARTS REMOVED/INSTALLED/REPLACED
| Replaced Part or Performed Procedure | Necessary Procedure | Effect/Inoperative Function when Necessary Procedure not Performed | Link |
|---|---|---|---|
| Auxiliary battery terminal is disconnected/reconnected | Perform steering sensor zero point calibration | Lane Departure Alert System (w/ Steering Control) | Refer to INITIALIZATION [04/2018 - 08/2021] |
| Pre-collision System | |||
| Intelligent Clearance Sonar System* | |||
| Lighting System (for HV Model with Cornering Light) | |||
| Memorize steering angle neutral point | Parking Assist Monitor System | Refer to INITIALIZATION [04/2018 - ] | |
| Panoramic View Monitor System | Refer to INITIALIZATION [04/2018 - ] | ||
|
Inspection after repair |
|
Refer to INITIALIZATION [04/2018 - 08/2019] , or refer to INITIALIZATION [08/2019 - 08/2021] |
*: When performing learning using the Techstream.
WARNING:
- Never perform work on fuel system components near any possible ignition sources.
- Vaporized fuel could ignite, resulting in a serious accident.
- Do not perform work on fuel system components without first disconnecting the cable from the negative (-) auxiliary battery terminal.
- Sparks could cause vaporized fuel to ignite, resulting in a serious accident.
- To prevent serious injury due to fuel spray from the high-pressure fuel lines, always discharge fuel system pressure before removing any fuel system components.
NOTE:
This procedure includes the removal of small-head bolts. Refer to Small-Head Bolts of Basic Repair Hint to identify the small-head bolts.
Refer to PRECAUTION [04/2018 - ]