LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2020 >> Avalon Limited >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 33 (Power Steering System - Diagnostics - Introduction (Hybrid)) >> POWER STEERING SYSTEM (for HV Model) >> DTC Check / Clear [08/2019 - ] >> DTC Check / Clear [08/2019 - ]

DTC Check / Clear [08/2019 - ]

WARNING: This page is about a different variant/trim than selected.
  1. CHECK DTCs (USING TECHSTREAM) 
    1. Turn the power switch off.
    2. Connect the Techstream to the DLC3.
    3. Turn the power switch on (IG).
    4. Turn the Techstream on.
    5. Enter the following menus: Chassis / EMPS / Trouble Codes.

      Chassis > EMPS > Trouble Codes 

    6. Check the details of the DTCs.

      Refer to DIAGNOSTIC TROUBLE CODE CHART [04/2018 - ] 

  2. CLEAR DTCs (USING TECHSTREAM) 
    1. Turn the power switch off.
    2. Connect the Techstream to the DLC3.
    3. Turn the power switch on (IG).
    4. Turn the Techstream on.
    5. Enter the following menus: Chassis / EMPS / Trouble Codes.

      Chassis > EMPS > Trouble Codes 

    6. Clear the DTCs.

      Chassis > EMPS > Clear DTCs 

    7. Turn the power switch off.
    8. Disconnect the Techstream from the DLC3.
scientia non olet · About LEMON Manuals